HOME	About Us	Contact Us	Shipping	Guarantee	Delivery
		Pricing Materials	Payment		Veneer
Tracking Number Handles Knobs Slides Hinges Amerock Hinges	European Hinges	Blum Hinges	Blum Soft Close	QUOTE   PAGE

Raised Panel Doors	Flat Panel Doors	Frame Doors	Raised Panel Drawer Fronts	Flat Panel Drawer Fronts	Slab Drawer Fronts	Panel Raisers	Edges		Shaker Doors

Short Quick
Course on
European Hinges

BLUM
CONCEALED HINGES

Short Quick
Course on
European Hinges

When you have the Plates on the Hinges and the Hinges on the door, hold the Plate to the "edge" of your face frame.   You will see 2 little TABS on the Plate, move the Plate back until these are touching the FACE of your frame.  Your distance back is now set.

Use 2 wood screws (not included) suitable for your material to fasten the Plate to the cabinet frame. Keep the screws in the middle of the elongated holes, this will give you up & down adjustment if needed.

If your cabinets are frameless, you can still use this Plate as described above.

Try that with a cheap gable Plate from the box stores. Where is 37mm back, etc????  Don't take me wrong, that system is ok if you're set up for it, but are YOU?

You have 6 way adjustment here:
#3 will allow you up and down.
#2 moves the door left and right.
AND #1, the second BIG DEAL on this Hinge. This CAM screw will move the door in and out.  CAM means there is no need to loosen a screw first, move the door and retighten the screw.  This and the "Thumb" pressure to install this Hinge to the door makes this a CLIP TOP INSERTA.

If you tried this with just the Hinge and Plate, you probably gave up. BUT, with it fastened to the cabinet it will be easy.  At the end of the Hinge is a small lever, rock it towards the face of the Hinge and the Hinge and Plate will separate.  It's a good idea to hold the door at  this point!