HOME About Us Contact Us Shipping Guarantee Delivery   Pricing Materials Payment   Veneer Tracking Number Handles Knobs Slides Hinges Amerock Hinges European Hinges Blum Hinges Blum Soft Close QUOTE   PAGE                     Raised Panel Doors Flat Panel Doors Frame Doors Raised Panel Drawer Fronts Flat Panel Drawer Fronts Slab Drawer Fronts Panel Raisers Edges   Shaker Doors

      See a larger selection of hinges at our new hardware site.
 www.knobsplus.com/   

		3211 -- Full Overlay. With this hinge you will get up to 5/8" coverage of your frame or gable on hinge side of door. Adjustable   ± 1/8"..You determine how much coverage (overlay) you want on other side. For pricing, ordering and other hinges, click here.
		3212 -- Half Overlay. With this hinge you will get 1/4" coverage of your frame or gable on hinge side of door. Adjustable   ± 1/8".. You determine how much coverage (overlay) you want on other side. For pricing, ordering and other hinges, click here.
		3203 -- Plate. Used with all our hinges. Used for Face Frame and Frameless cabinets. The hinge clips on this, no tools required for installing or removing door from cabinet after clip is installed. (screws not included) For pricing, ordering and other hinges, click here.

INSTALLING HINGE TO THE DOOR.

	Back of door will be drilled with 2-8mm and 1-35mm hole to receive hinge.( Blum Pattern) We provide the service at extra cost.
	Simply lay door face down on a flat surface, line up dowels on hinge with holes in door, and drop hinge into holes. We are soon changing these to a tap in hinge.
	With proper screw driver turn screws approximately 1/4 turn all the way to the stop.  We are soon changing these to a tap in hinge.  Hinge is installed. Simply reverse procedure to remove. We suggest hanging all your doors first before finishing. Then you can UNCLIP the hinges from the plate, and even remove the hinge from the door for finishing.

	Install Plates on hinges. Start at end with mounting holes.
	Rock hinge towards clip and Push.

	On the plate is little tabs, these will sit on the front edge of the frame or gable. Your distance back is now automatically set. Just move door up or down by whatever method you use ( a strip of wood clamped to bottom of cabinet) and screw in place. Be sure to put screw in center of elongated hole so it can be adjusted later.(screws not included)
	1. Moves door away from or closer to frame. 2. Moves door left or right. 3. Moves door up and down.
	To remove door from your finished installation, simple hold door and push in on tab at end of hinge.

For pricing, ordering and other hinges, click here.

The methods and parts used in above description will work in 99% of all applications. HOWEVER......
On a lazy susan or if you are using pull outs, these hinges will not swing the door open far enough. You will need to use 165 degree opening hinges. We now stock these hinges.
If you have a corner cabinet at 45 degrees and didn't build your box to use standard hinges, you may need a 45 degree hinge. This hinge when closed sits at 45 degree, not 90 degree like other hinges. We now stock these hinges.

If pricing doors at the same time as hinges, use our Quote Page and fill in the qualities of hinges you want.

WE HAVE MOVED OUR HANDLES, KNOBS & MOST OF OUR HINGES OVER TO OUR HARDWARE SITE
www.knobsplus.com/

Copyright 2000 Randy Howse Custom Doors. All rights reserved.