Hinge Half Overlay

3212 /B675N-- Half Overlay. With this hinge you will get 1/4" coverage of your frame or gable on hinge side of door. Adjustable ą 1/8".. You determine how much coverage (overlay) you want on other side. Sold by EACH, not a pair, PLATE required.

INSTALLING HINGE TO THE DOOR.

Back of door will be drilled with 2-8mm and 1-35mm hole to receive hinge.( Blum Pattern)

We provide the service at extra cost.

Simply lay door face down on a flat surface, line up dowels on hinge with holes in door, and tap in with a hammer.

INSTALLING DOORS TO THE BOXES

Install Plates on hinges.

Start at end with mounting holes.

Rock hinge towards clip and Push.

INSTALLING DOORS TO CABINETS

On the plate is little tabs, these will sit on the front edge of the frame or gable. Your distance back is now automatically set. Just move door up or down by whatever method you use ( a strip of wood clamped to bottom of cabinet) and screw in place. Be sure to put screw in center of elongated hole so it can be adjusted later.(screws not included)

1. Moves door away from or closer to frame.
2. Moves door left or right.
3. Moves door up and down.

To remove door from your finished installation, simple hold door and push in on tab at end of hinge.

	On the plate is little tabs, these will sit on the front edge of the frame or gable. Your distance back is now automatically set. Just move door up or down by whatever method you use ( a strip of wood clamped to bottom of cabinet) and screw in place. Be sure to put screw in center of elongated hole so it can be adjusted later.(screws not included)
	1. Moves door away from or closer to frame. 2. Moves door left or right. 3. Moves door up and down.
	To remove door from your finished installation, simple hold door and push in on tab at end of hinge.