5/8" coverage of your frame or gable on hinge side of door. Adjustable ± 1/8". You determine how much coverage (overlay) you want on other side. Sold by EACH, not a pair, PLATE required.
|
|
3211 -- Full Overlay. With this hinge you will get
up to 5/8" coverage of your frame or gable on hinge side of door. Adjustable ± 1/8". You determine how much coverage (overlay) you want on other side. Sold by EACH, not a pair, PLATE required. |
NO SCREWS TO INSTALL HINGE TO DOOR ( see below ). HINGE CLIPS TO PLATE, NO TOOLS.
INSTALLING HINGE TO THE DOOR.
 |
Back of door will be drilled with 2-8mm and 1-35mm hole to receive hinge.( Blum Pattern) We provide the service at extra cost.
|
 |
Simply lay door face down on a flat surface, line up dowels on hinge with holes in door, and drop hinge into holes. |
 |
With proper screw driver turn screws approximately 1/4 turn all the way to the stop. Hinge is installed. Simply reverse procedure to remove. We suggest hanging all your doors first before finishing. Then you can UNCLIP the hinges from the plate, and even remove the hinge from the door for finishing. |
INSTALLING DOORS TO THE BOXES
 |
Install Plates on hinges. Start at end with mounting holes. |
 |
Rock hinge towards clip and Push. |
INSTALLING DOORS TO CABINETS
 |
On the plate is little tabs, these will sit on the front edge of the frame or gable. Your distance back is now automatically set. Just move door up or down by whatever method you use ( a strip of wood clamped to bottom of cabinet) and screw in place. Be sure to put screw in center of elongated hole so it can be adjusted later.(screws not included) |
 |
1. Moves door away from or closer to frame. 2. Moves door left or right. 3. Moves door up and down. |
 |
To remove door from your finished installation, simple hold door and push in on tab at end of hinge. |